■KM-1U Series
If you are using 3D data (IGES, STEP data) with CAD software, please download here.
See below for 2D diagrams.
Precautions for Mounting
When Fixing a Flat Surface on the Rotating Part
When fixing something with a flat surface to KeiganMotor, use the M3 screw hole on the top of the rotor.
When removing the fixing plate (doughnut-shaped plate) that comes with the product at the initial stage, use a 2mm wide hexagon wrench.
When Positioning a Prototype Part on the Rotating Part
Please use the Φ18 boss in the center of the top surface of the rotor of Keiganmotor. Refer to the diagram below for tolerance.
When Installing the Main Body
Please use the M5 screw holes at the four corners. Since it is a through hole, it can be installed from either side.
■KM-1S Series
If you are using 3D data (IGES) with CAD software, please download from here.
See below for 2D diagrams.

Precautions for Mounting
When selecting screws, make sure that the depth from the top is 3mm. Using screws 3mm or more may damage the KeiganMotor.
■About Overhang Loads
Please refer to the following for the allowable moment load and overhang load of the KeiganMotor KM-1U(KM-1).
PDFファイル